CVE-2026-10642Medium· 6.5▾ SunlitThe Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) i…
▾ Sunlit zone — Low / medium · no exploitation signal
impact 35.8 · likelihood 0 · exploitation 0
Need a working PoC? Pro members can cast a request and our team develops one — it lands right here.
Stakeholder-Specific Vulnerability Categorization from CISA's ADP record at CVE.org: whether exploitation is observed, whether an attack can be automated, and how much of the system is at stake.
Exploit-prediction probability, daily snapshots since Aug 1.
Disclosure to exploitation, from the record and what we observed since indexing it.
Disclosed via NVD
Last analysed / modified upstream
0.2%
0.2% → 0.2%
The Zephyr PL011 UART driver (drivers/serial/uart_pl011.c) contains an unbounded software loop in pl011_irq_tx_enable() that repeatedly invokes the interrupt-driven application callback while the TX interrupt mask bit (PL011_IMSC_TXIM) is set, to work around the controller's level-transition TX-interrupt behavior. When CTS hardware flow control is enabled (devicetree hw-flow-control or runtime UART_CFG_FLOW_CTRL_RTS_CTS) and the wired serial peer de-asserts CTS, the controller stops draining the TX FIFO; pl011_fifo_fill() then returns 0 on every call while the application still has pending data and therefore never disables the TX interrupt. The loop condition never clears, so the thread that called uart_irq_tx_enable() (e.g. h4_send() in the Bluetooth HCI H4 driver) spins indefinitely, hanging the executing context and stalling the transport — a denial of service (CWE-835). An attacker controlling the device attached to the UART's CTS line can trigger the hang by withholding CTS during transmission. Impact is availability only; there is no memory-safety, confidentiality, or integrity consequence. The vulnerable loop was introduced in commit b783bc8448ef (Feb 2025) and shipped in releases v4.1.0 through v4.4.0. The fix breaks out of the loop when CTS is blocking and arms the CTS modem-status interrupt to resume transmission when CTS re-asserts.
zephyr >= 4.1.0, < 4.5.0Upgrade past the affected range:
zephyr 4.5.0Connected by shared product, vendor, weakness, or advisory.
CVE-2025-2962High· 7.5A denial-of-service issue in the dns implemenation could cause an infinite loop.
CVE-2026-15923Medium· 4.6The Zephyr SDIO subsystem function sdio_io_rw_extended_helper() in subsys/sd/sdio.c finishes transfers with a byte-I/O loop that uses size = MIN(remaining, func->cis.max_blk_size) as the per-iteration step
CVE-2026-10686Medium· 5.8Zephyr's IPv6 forwarding path re-sent routed unicast packets without ever decrementing the IPv6 hop limit
CVE-2026-82962Medium· 6.5Out-of-bounds write in Zephyr Ethernet L2 when adding the link-layer header to a forwarded packet
CVE-2026-82961High· 7.8Unvalidated pin index in GPIO syscall handlers allows out-of-bounds kernel writes from user mode
CVE-2026-19742Low· 3.7IPv6 stable and temporary interface identifiers derived from a non-cryptographic PRNG secret key