CVE-2026-98014High· 7.0▾ TwilightIn the Linux kernel, the following vulnerability has been resolved: net/mlx5: E-Switch, prevent mc_list repopulation during vport disable In mlx5_esw_vport_disable(), move esw_apply_vport_rx_mode() ahead of esw_vport_change_handle_lock…
▾ Twilight zone — High severity, or a signal on a lesser flaw
impact 38.5 · likelihood 0 · exploitation 0
Need a working PoC? Pro members can cast a request and our team develops one — it lands right here.
Exploit-prediction probability, daily snapshots since Sep 27.
Disclosure to exploitation, from the record and what we observed since indexing it.
Disclosed via NVD
0.2%
— → 7
none → high
Last analysed / modified upstream
0.2% → 0.2%
In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: E-Switch, prevent mc_list repopulation during vport disable
In mlx5_esw_vport_disable(), move esw_apply_vport_rx_mode() ahead of esw_vport_change_handle_locked() so vport->allmulti_rule is NULL before the change handler observes it.
During FW-fatal recovery the disable runs while dev->state == INTERNAL_ERROR. The promisc query inside esw_update_vport_rx_mode() fails and returns early, leaving vport->allmulti_rule intact, so esw_update_vport_mc_promisc() runs and adds MLX5_ACTION_ADD entries to vport->mc_list whose flow rules are then installed in the FDB by esw_add_mc_addr(). esw_destroy_legacy_table() tears down the FDB with those refs still held, corrupting the sub-tree and leaving dangling flow_rule pointers in vport->mc_list.
Two-stage failure on echo 1 > /sys/bus/pci/devices/<bdf>/reset:
refcount_t: underflow; use-after-free. tree_put_node+0xef/0x110 [mlx5_core] clean_tree+0x44/0xd0 [mlx5_core] (x5) mlx5_fs_core_cleanup+0x57/0x1c0 [mlx5_core] mlx5_unload+0x65/0xd0 [mlx5_core] ... mlx5_health_try_recover
BUG: unable to handle page fault for address: 0000000003000055 down_write+0x1c/0x60 mlx5_del_flow_rules+0x33/0x1f0 [mlx5_core] esw_del_mc_addr+0x7b/0x170 [mlx5_core] esw_apply_vport_addr_list+0x56/0xf0 [mlx5_core] esw_vport_change_handle_locked+0x28b/0x310 [mlx5_core] mlx5_esw_vport_enable+0x270/0x4a0 [mlx5_core] ... mlx5_load ... mlx5_health_try_recover
esw_apply_vport_rx_mode(false, false) clears vport->allmulti_rule via its local state machine even when the FW del fails. With the rule NULL the !IS_ERR_OR_NULL(allmulti_rule) gate in the change handler closes, no rules are installed during disable, and the reload starts with a clean mc_list.
Refer to the linked advisories for vendor-supplied fixes and affected version ranges.
Field changes observed since this record was first indexed.
Connected by shared product, vendor, weakness, or advisory.
CVE-2025-39977High· 7.8In the Linux kernel, the following vulnerability has been resolved: futex: Prevent use-after-free during requeue-PI syzbot managed to trigger the following race: T1 T2 futex_wait_requeue_pi() fute…
CVE-2024-57804High· 7.3scsi: mpi3mr: Fix corrupt config pages PHY state is switched in sysfs
CVE-2024-47794High· 7.8bpf: Prevent tailcall infinite loop caused by freplace
CVE-2026-100070Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_nat_sip: rewind offset when NAT shrinks the packet sashiko says: If map_addr() changes the packet length, such as when the public NAT IP string is shor…
CVE-2026-100071Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: net: hsr: free learned nodes on device setup failure hsr_dev_finalize() can fail after a lower-device RX handler has already been registered (slave A is added before t…
CVE-2026-99100Nonewifi: p54: validate firmware record lengths