CVE-2026-98067Medium· 5.5▾ SunlitIn the Linux kernel, the following vulnerability has been resolved: erofs: disable LZ4 rolling decompression for now LZ4 rolling decompression [1] was introduced to reduce the memory footprint of temporary pages: For many cases, it i…
▾ Sunlit zone — Low / medium · no exploitation signal
impact 30.3 · likelihood 0 · exploitation 0
Need a working PoC? Pro members can cast a request and our team develops one — it lands right here.
Exploit-prediction probability, daily snapshots since Sep 27.
Disclosure to exploitation, from the record and what we observed since indexing it.
Disclosed via NVD
0.2%
— → 5.5
none → medium
Last analysed / modified upstream
0.2% → 0.2%
In the Linux kernel, the following vulnerability has been resolved:
erofs: disable LZ4 rolling decompression for now
LZ4 rolling decompression [1] was introduced to reduce the memory footprint of temporary pages:
For many cases, it is needed for users to read small data within a compressed extent (pcluster), either due to random small read, or since uptodate folios (typically order-0) cannot be reused for decompression again since decompression algorithm refills already-uptodate folios.
Rolling decompression works because LZ4 is LZ77-based and only refers to the most recent 64 KiB of decompressed data, so in theory only a bounded rolling window of temporary pages is needed when decompressing.
It can save a lot of temporary memory, e.g. 601,960-byte data can be compressed into a 256k LZ4 compressed extent, which means it needs 146 extra pages per request in the worst case if rolling decompression is disabled.
However, the upstream LZ4 implementation is not under EROFS' control: For example, the literal copy memmove() may still copy long literals backward on x86 based on the address comparison even when the source and destination ranges do not overlap (IOWs, inline decompression doesn't need to be considered here). That breaks the rolling assumption and makes the optimization broken.
Disable it for now to make sure the data correctness first since EROFS is used everywhere now: The rolling window approach can be revived once we either ensure that the official LZ4 code always copies forward for non-overlapping ranges or maintain our own LZ4 implementation in EROFS.
The main impact is a higher runtime memory footprint; However, recent commit 0f6273ab4637 ("erofs: add a reserved buffer pool for lz4 decompression") helps mitigate this when enabled but it's still not perfect.
[1] https://www.usenix.org/conference/atc19/presentation/gao § 3.3 Decompression
Refer to the linked advisories for vendor-supplied fixes and affected version ranges.
Field changes observed since this record was first indexed.
Connected by shared product, vendor, weakness, or advisory.
CVE-2024-57804High· 7.3scsi: mpi3mr: Fix corrupt config pages PHY state is switched in sysfs
CVE-2024-47794High· 7.8bpf: Prevent tailcall infinite loop caused by freplace
CVE-2026-100070Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_nat_sip: rewind offset when NAT shrinks the packet sashiko says: If map_addr() changes the packet length, such as when the public NAT IP string is shor…
CVE-2026-100071Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: net: hsr: free learned nodes on device setup failure hsr_dev_finalize() can fail after a lower-device RX handler has already been registered (slave A is added before t…
CVE-2025-39977High· 7.8In the Linux kernel, the following vulnerability has been resolved: futex: Prevent use-after-free during requeue-PI syzbot managed to trigger the following race: T1 T2 futex_wait_requeue_pi() fute…
CVE-2026-99118Nonedrm/i915/dmc: Harden DMC firmware payload parsing