CVE-2026-98406Medium· 5.5▾ SunlitIn the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: avoid WARN in set_bitrate_mask when sdata not in driver ieee80211_set_bitrate_mask() checks if the interface is running via ieee80211_sdata_running(), …
▾ Sunlit zone — Low / medium · no exploitation signal
impact 30.3 · likelihood 0 · exploitation 0
Need a working PoC? Pro members can cast a request and our team develops one — it lands right here.
Exploit-prediction probability, daily snapshots since Oct 16.
Disclosure to exploitation, from the record and what we observed since indexing it.
Disclosed via NVD
0.2%
— → 5.5
none → medium
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: avoid WARN in set_bitrate_mask when sdata not in driver
ieee80211_set_bitrate_mask() checks if the interface is running via ieee80211_sdata_running(), but it does not check if the interface is still present in the driver.
When sdata is running but IEEE80211_SDATA_IN_DRIVER is not set, the call reaches drv_set_bitrate_mask() in driver-ops.h which hits
wlan1: Failed check-sdata-in-driver check, flags: 0x0 WARNING: net/mac80211/driver-ops.h:884 at drv_set_bitrate_mask
Syzkaller triggers this via wext SIOCSIWRATE ioctl. The Call Trace shows wext_ioctl_dispatch() in wext-core.c dispatching the ioctl, calling ioctl_standard_call() for SIOCSIWRATE, which calls cfg80211_wext_siwrate() in wext-compat.c. That builds a bitrate mask and calls rdev_set_bitrate_mask() which ends up in ieee80211_set_bitrate_mask() in cfg.c. The interface is marked running via SDATA_STATE_RUNNING but flags is 0, so check_sdata_in_driver() fails.
When the interface is being torn down, or when wext ioctl is issued during interface bringup before drv_add_interface() sets IN_DRIVER, the running check passes while IN_DRIVER is clear.
Check IEEE80211_SDATA_IN_DRIVER in ieee80211_set_bitrate_mask() before calling the driver, returning -ENETDOWN. This avoids the WARN_ONCE in driver-ops.h and matches other cfg.c operations that bail early when not in driver.
This change should be safe because wiphy mutex is held in cfg80211_wext_siwrate() via guard(wiphy), and IN_DRIVER is set/cleared under RTNL and wiphy paths in drv_add_interface() and drv_remove_interface() in driver-ops.c, so the check is race-free against driver add/remove. Returning -ENETDOWN is the same error other not-running paths use and does not introduce new locking.
[also add second syzbot report]
Refer to the linked advisories for vendor-supplied fixes and affected version ranges.
Field changes observed since this record was first indexed.
Connected by shared product, vendor, weakness, or advisory.
CVE-2024-57804High· 7.3scsi: mpi3mr: Fix corrupt config pages PHY state is switched in sysfs
CVE-2024-47794High· 7.8bpf: Prevent tailcall infinite loop caused by freplace
CVE-2026-100070Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_nat_sip: rewind offset when NAT shrinks the packet sashiko says: If map_addr() changes the packet length, such as when the public NAT IP string is shor…
CVE-2026-100071Medium· 5.5In the Linux kernel, the following vulnerability has been resolved: net: hsr: free learned nodes on device setup failure hsr_dev_finalize() can fail after a lower-device RX handler has already been registered (slave A is added before t…
CVE-2025-39977High· 7.8In the Linux kernel, the following vulnerability has been resolved: futex: Prevent use-after-free during requeue-PI syzbot managed to trigger the following race: T1 T2 futex_wait_requeue_pi() fute…
CVE-2026-99118Nonedrm/i915/dmc: Harden DMC firmware payload parsing